Mounting The Flight Controller; Mounting The Motor Cowl - Reely SKY 20 89 95 Mode D'emploi

h) Mounting the Flight Controller
Figure 7, item 1 shows a possible installation site for
the flight controller. The assembly must be selected
individually according to flight controller used.
Figure 7, item 2 shows the assembly site of the
rechargeable battery. Here too, the later installation and
fastening must be performed individually with hook-and-
loop tapes.
The final position of the flight battery depends on the
weight of the components used but will usually be found
in the area of the wing socket (also see figure 10, item
2) to set the centre of gravity.
Figure 7
i) Mounting the Motor Cowl
Adjust the motor cowl and transfer to the spinner at
your own discretion depending on the motor used.
Independently of this, observe matching cooling of the
drive. Use the information from figure 8a as reference.
The motor cowl is attached with three grub screws
2 x 6 mm (figure 8b, item 1) each on the left and right
as well as at the bottom of the fuselage. Pre-drill the
correspondingly small holes into the fuselage and
„harden" them with instant adhesive.
The motor cowl must be installed so that the shape of
the motor cowl matches the wing contour (figure 8b,
item 2). The distance of the spinner back plate to the
motor cowl must be selected so that it is located at a
distance of about 2-3 mm in an area (figure 8b, item 3).
Figure 8a
Practical advice:
To be able to drill the perfectly matching holes for the
screws of the motor cowl, attach two paper strips to
the left and right of the fuselage with adhesive tape
with the motor cowl removed (figure 8a, item 1).
The paper strips must be attached so that the holes to
be drilled at the fuselage can be marked on the paper
strips.
Then fold the paper strips back again, apply the motor
cowl and mark the drill holes at the motor cowl as
indicated on the paper strips.
Figure 8b
35