Publicité
Les langues disponibles
Les langues disponibles
A A c c t t i i v v a a t t i i n n g g a a n n d d r r e e s s e e t t t t i i n n g g C C P P R R
When you activate for CPR, the system deflates and the I I n n T T o o u u c c h h control display will change.
W W A A R R N N I I N N G G - - Always make sure that the operator has access to the CPR straps.
To activate for C C P P R R , pull the red CPR strap straight out from the support surface (Figure 7). The CPR straps are located on
the left and right side of the foot end of the support surface. You can activate either one or both CPR straps.
F F i i g g u u r r e e 7 7 – – C C P P R R a a c c t t i i v v a a t t i i o o n n
T T o o r r e e s s e e t t f f o o r r C C P P R R , pull down on red CPR strap (Figure 8). The support surface will begin to reinflate.
R R e e l l o o c c a a t t i i n n g g t t h h e e s s u u p p p p o o r r t t s s u u r r f f a a c c e e
Relocating the support surface is for the purpose of cleaning or moving to another InTouch bed frame.
W W A A R R N N I I N N G G
• Do not move the support surface without assistance.
• Do not use the support surface as a transfer device to avoid the risk of patient injury.
P P r r e e r r e e q q u u i i s s i i t t e e : : Minimum of two operators are required to relocate the support surface and setup this product.
1. Make sure that there is not a patient on the support surface.
2. Remove the linens.
3. Unplug the power cord for the support surface from the foot end auxiliary power outlet.
4. Unplug the support surface connector.
5. Remove the headboard and footboard
6. Position an operator at each end of the support surface and remove the support surface and relocate.
N N o o t t e e - - Use all four handles when relocating the support surface.
N N o o t t e e - - See ( Setup (page 9)) of the support surface.
7. Reinstall the I I n n T T o o u u c c h h headboard and footboard.
EN
14
F F i i g g u u r r e e 8 8 – – C C P P R R r r e e s s e e t t
2972-009-001 AB.0
Publicité
