Fitting The Name-Tag; Switching The Installation On; Operation; Responding To A Visitor - SOMFY V200 RTS Manuel D'installation Et D'utilisation

2-wire colour video entry phone - V200 RTS

fitting the name-tag

[1]. Press and push on the right-hand side of the label.
[2]. Use a screwdriver to lift and remove the name-tag protector.
[3]. Write your name on the white label using a permanent marker, then replace the label and its protector in their housing.

switching the installation on

After fitting, reconnect the gate or door-opener/electric lock motorisation to the power supply.
Next connect the monitor power plug to an electrical socket.
Important: The power plug must be installed close to the monitor and must be easily
STOP
accessible.

opEratIoN

When a visitor presses the call button on the door station, the monitor rings twice and an image of the visitor is displayed.

► responding to a visitor

Press the microphone activation button . The microphone activation indicator light comes on.
You can communicate with your visitor.
Note: communication with your visitor can last a maximum of 2 minutes.
If you press the microphone activation button again, the monitor screen goes off and communication is cut off.
► opening the gate or the electric lock or door-opener
While communicating with a visitor
Press the unlock button .
The monitor screen goes off when the door opens or the door-opener/electric lock is released.
While there is no communication with a visitor
Press the microphone activation button , the screen comes on, then press the unlock button to operate the gate (to close it for
example) or the door-opener/electric lock. The screen goes off
Note: The monitor screen must be on to be able to operate the gate or door-opener/electric lock using the unlock button .
10
Copyright © 2011 Somfy SAS. All rights reserved.