SOMFY V200 RTS Manuel D'installation Et D'utilisation page 33

► programming a somfy rts lighting receiver
on a somfy rts remote control terminal or socket
[1]. Check that the remote control terminal/socket is powered on.
[2]. Select the second channel by pressing the channel selection button on the monitor.
[3]. Press the programming button on the remote control terminal/socket until the indicator light flashes.
[4]. Use a fine-tipped object to briefly press the PROG button at the back of the monitor (above the battery housing).
The indicator light on the remote control terminal/socket will come on permanently, then go off.
2
3
2 s
2 s
Examples of Somfy remote control terminals and socket
Note: To clear the programming on the video entry phone on a Somfy remote control terminal or socket, repeat all the steps detailed above.
Copyright © 2011 Somfy SAS. All rights reserved.
STOP
2 s
2-wire colour video entry phone - V200 RTS
4
13