Connecting The Door Station; Alimentation - SOMFY V200 RTS Manuel D'installation Et D'utilisation

Connecting the door station

► to a gate motorisation
Note: When the motorisation is solar-powered, the wired controls are deactivated. In this case, you must use the monitor's wireless control to
control your gate motorisation (see page 17).
[1]. Disconnect the motor from the mains power supply.
[2]. Remove the cover from the control cabinet or from the motor containing the electronics.
[3]. On motorisations equipped with electronics represented in the view on the left, connect the dry contact output (COM and NO) on the door
station to terminals 3 and 4 (yellow "BUS" label) on the motorisation electronics.
On motorisations equipped with electronics represented in the view on the right, connect the dry contact output (COM and NO) on the door
station to terminals 3 and 5 on the motorisation control cabinet to open the main gate or to terminals 3 and 6 to open the pedestrian gate.
Com
No
door station
NC COM NO
To connect the door station to another brand of gate motorisation, please refer to the installation guide for that motorisation.
► to a door-opener/electric lock
[1]. Disconnect the door-opener/electric lock from the power supply.
[2]. Connect the dry contact output (COM and NO) on the door station to the door-opener/lock and its power supply according to the diagram
below.
Copyright © 2011 Somfy SAS. All rights reserved.
3
4
motorisation
electronics
NC COM NO
door station
NC COM NO

Alimentation

12V or 24V*
12V ou 24V*
power supply
door-opener/electric
Gâche /
lock*
Serrure électrique*
1A max
1a max.
2-wire colour video entry phone - V200 RTS
motorisation
electronics
230V power
Alimentation
supply
secteur 230V
* not supplied
9