Fitting The Name Plate; Switching The Installation On; Video Entry Phone Settings; Monitor Settings - SOMFY V100+ Notice D'installation Et D'utilisation

Video phone V100+

5.2 Fitting the name plate

[1]. Turn the call button anticlockwise until the engraved marking then remove.
[2]. Remove the round to access the name plate label.
[3]. Write your name on the white label using a permanent marker, then replace the label and
its membrane in their housing.
[4]. Reassemble the call button on the door station using the marks then turn
clockwise until it locks.

5.3 Switching the installation on

Once installation is complete, reconnect the gate motorisation to the power supply.
Then connect the mains adaptor provided to an electrical socket.
Important: The power plug must be installed close to the monitor and must be easily
accessible.

6.1 Monitor settings

Press the "microphone activation" button for 2 seconds to display the main menu on your monitor. Press the "microphone activation" button again to
switch between the different menu options. When you switch from one icon to another, the option name is highlighted. Press the "electric latch/lock" and
"gate" buttons to change the settings of the highlighted option.
6.1.1 Settings accessible if the monitor is not in communication
The following table describes all the menu options and their functions
Enables the monitor ring tone to be selected (choice of 6).
This is used to adjust the volume of the monitor bell.
This is used to adjust the screen brightness on the monitor.
This is used to adjust the screen colours on the monitor.
Enables the contrast on the monitor screen to be adjusted.
Enables the latch activation time to be defined (2, 5 or 10 s)
Enables the monitor to be defined as the main or secondary monitor*.
1
2
Enables you to quit the menu
* In the event of an installation with an additional monitor. For more information, read the instructions for the relevant monitor.
Note: In the event of an installation with a single monitor, the setting must be set to "1"
6.1.2 Settings accessible if the monitor is in communication
The following table describes all the menu options and their functions
Enables the conversation volume to be adjusted.
This is used to adjust the screen brightness on the monitor.
This is used to adjust the screen colours on the monitor.
Enables the contrast on the monitor screen to be adjusted.
Copyright © 2019 SOMFY ACTIVITES SA. All rights reserved.

6. VIDEO ENTRY PHONE SETTINGS

1 2
SELECT
Display
Modification
menu /
of option
Choice of
settings
options
EN
10