Fitting The Name Plate - SOMFY V300 Manuel D'installation Et D'utilisation

EN

5.2 Fitting the name plate

c
b
a
[4]. Write your name on the white name plate using a permanent marker:
Xxxxxxxxxxxxxxxx
Note: the name plate holder has two cutaways that correspond to lugs located behind the
name plate holder.
12
[1]. Press and turn the button
anticlockwise until the stop block
using the button lugs.
[2]. Li the button to remove it, as the
name plate holder is placed behind
the base plate of the button.
[3]. Remove the button by turning the
base plate anticlockwise until the
stop block using the small lugs inside
this plate.
Note: When the base plate is in the
unlocked position, the marker on the base
plate and the ring are aligned.
a Base plate
b Name plate
d
c Glass
d Ring
- ensuring that you align the name with the cutaways on the name plate for the
one-residence button,
- paying attention to the reading direction of each name plate for the two-residence
button.
a
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
V300
b
c
b c
d
Yyyyyyyyyyyyyy
Zzzzzzzzzzzz