Wirelessly Controlling A Somfy Rts Unit From The Monitor; Maintenance; Replacing The Battery; Cleaning - SOMFY V200 RTS Manuel D'installation Et D'utilisation

Wirelessly controlling a somfy rts unit from the monitor

[1]. Selected the channel associated with the equipment that you want to control by pressing the channel selection button: the indicator light for the
selected channel will flash.
Press the channel selection button as many times as necessary until the indicator lights show the required channel.
[2]. Control your equipment using the Open/on, STOP and Close/off buttons on the monitor.
The equipment will react as show in the table below:
Equipment controlled
Garage door
Lighting
Roller shutter
Gate

maINtENaNCE

replacing the battery

Equipment is controlled wirelessly thanks to a radio transmitter built into the monitor which is battery powered.
If wireless control does not work properly, the battery may be low and should be changed.
To change the battery, open the battery housing at the back of the monitor (mark 15, page 4) and replace the flat battery with one of the same
type (CR2430-type 3V battery).

Cleaning

The video entry phone should be cleaned using a soft, dry cloth, not with solvent.
Before cleaning, switch off the equipment.

tEChNICal spECIfICatIoNs

monitor
Power supply
Screen
Max. communication time
Operating temperature
Radio transmitter
door station
Power supply
Camera
Night vision
Operating temperature
Copyright © 2011 Somfy SAS. All rights reserved.
press button:
open/on
Open
On
Open
Open
Frequency
Power supply
Range
stop
Off
-
Stop (if roller shutter moving)
Off
AC 100V-240V/50-60 Hz; DC 17V
Colour - TFT 7" - resolution: 480 x 234 pixels
2 minutes
-10°C to +55°C
433.42 MHz
3 V type CR2430
200 m (in open space)
14.5 V DC
1/3 CCD 72°
0.05 LUX visible LEDs
-20°C to +55°C
2-wire colour video entry phone - V200 RTS
Close/off
Close
Off
Close
Close
17