Fitting The Name Tag; Switching The Installation On; Video Entry Phone Settings; Monitor - SOMFY V100 Notice D'installation Et D'utilisation

Video door phone V100

5.2 Fitting the name tag

[1]. Press and push the le -hand side of the label.
[2]. Using a screwdriver, li and remove the name tag protector.
[3]. Write your name on the white label using a permanent marker, then replace the label and
its protector in their housing.

5.3 Switching the installation on

Once installation is complete, reconnect the gate motorisation to the power supply.
Next connect the monitor power plug to an electrical socket.
Important: The power plug must be installed close to the monitor and must be easily
accessible.

6.1 Monitor

Bell volume dial
Speaker volume dial
Screen colours dial
Screen brightness dial
6.1.1 Changing the monitor bell
There is a choice of two bells for the monitor.
To change the monitor bell, press and hold down the microphone activation button
To change the bell again, repeat the above operation.

6.2 Door station

6.2.1 Adjusting the speaker volume

To adjust the door station speaker volume, use a screwdriver to turn the
button on the back of the door station:
• clockwise to increase the volume,
• anti-clockwise to reduce the volume.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.

6. VIDEO ENTRY PHONE SETTINGS

This is used to adjust the volume of the monitor bell.
This is used to adjust the volume of the monitor.
This is used to adjust the screen colours on the monitor.
This is used to adjust the screen brightness on the monitor.
for approximately 7 seconds. The new monitor bell sounds twice.
EN
Button to
adjust the
speaker
volume
10