VIdEo ENtry phoNE sEttINgs
► monitor
Bell volume dial
Screen colours dial
Screen brightness dial
Speaker volume dial
► door station
To adjust the door station speaker volume, use a screwdriver to turn the
button on the back of the door station:
• clockwise to increase the volume,
• anticlockwise to decrease the volume.
CoNtrollINg somfy rts WIrElEss EquIpmENt
programming the monitor on a somfy rts unit
The monitor is equipped with a Somfy Radio Technology (RTS) transmitter. It is only compatible with devices equipped with Somfy Radio
Technology (RTS).
It is used to control the following Somfy equipment, individually or simultaneously:
• garage door motorisation,
• lighting receiver,
• roller shutter motorisation,
• gate motorisation.
This functionality is possible thanks to a channel system, identified by indicator lights.
Each channel corresponds to an individual remote control and can be used to control one or more devices. There is
no limit to the number of pieces of equipment that can be controlled by a single channel. The channel selection button
is used to navigate between channels (mark 8, page 4).
selecting the chosen channel to wirelessly control a piece of equipment
Press the channel selection button the indicator light for the selected channel will flash.
Press the channel selection button as many times as necessary until the indicator lights show the required channel.
Important: Check that the equipment to be controlled wirelessly is not too far away from the monitor.
Copyright © 2011 Somfy SAS. All rights reserved.
This is used to adjust the volume of the monitor bell.
This is used to adjust the screen colours on the monitor.
This is used to adjust the screen brightness on the monitor.
This is used to adjust the volume of the monitor.
2-wire colour video entry phone - V200 RTS
Button to adjust the speaker
volume
+
NC COM NO
-
Channel 1:
Canal 1 :
Channel 2:
Canal 2 :
Channel 3:
Canal 3 :
Channel 4:
Canal 4 :
11