Emetteur Rts D'origine Original Rts Transmitter; Emetteur Rts D'origine; Emetteur Rts D'origine Monitor Moniteur - SOMFY V200 RTS Manuel D'installation Et D'utilisation

► programming a somfy rts radio roller shutter motorisation
[1]. Identify the original control of the roller shutter, i.e. the remote control or the control point which only controls this roller shutter.
Note: - If the original control is lost or broken, and it is the only one to control the roller shutter, contact one of our Somfy advisors.
- If another control operates the roller shutter, use that to follow the steps below.
[2]. Partially open the roller shutter using the original control.
[3]. Press the PROG button on the original control until the roller shutter makes an up and down movement (or a series of 3 beeps). The
programming function is activated for 2 minutes.
[4]. Select the third channel by pressing the channel selection button on the monitor.
[5]. Use a fine-tipped object to briefly press the PROG button at the back of the monitor (above the battery housing). The roller shutter will make
an up and down movement (or a series of 8 beeps).
3

Emetteur RTS d'origine

original rts transmitter
Emetteur RTS d'origine
Back of control point
4
Moniteur
5
Emetteur RTS d'origine
monitor
Moniteur
Note: To clear the programming on the video entry phone on a Somfy roller shutter motorisation, repeat all the steps detailed above.
Moniteur
Copyright © 2011 Somfy SAS. All rights reserved.
STOP
STOP
or
Back of remote control
STOP
2-wire colour video entry phone - V200 RTS
15