Installing The Door Station - SOMFY V200 RTS Manuel D'installation Et D'utilisation

2-wire colour video entry phone - V200 RTS

INstallINg thE door statIoN

Avoid installing the camera facing a light source, images of visitors may be impaired.
We recommend that silicon sealant is applied between the rain shield and the wall/pillar (but not below the rain shield) and that the door station
is fitted at a height of approximately 1.60 m.
[1]. Route all the cables into the rain shield.
[2]. Fix the rain shield to the wall/pillar.
[3]. Connect:
- the monitor cable to the first 2 terminals on the door station
- the cable from the motorisation or door-opener/electric lock to the dry contact output (COM and NO) on the door station.
Note: The direction of the cables is not important.
To feed the cables into the terminals, use a screwdriver to press on the square with the notch, feed the wires in, then release.
[4]. Position the door station in the rain shield.
[5]. Screw the door station to the rain shield using the Allen key.
1
3
monitor
cable
8
NC COM NO
Electric lock/door-opener or
gate motorisation cable
2
4 5
Copyright © 2011 Somfy SAS. All rights reserved.