Publicité
Les langues disponibles
Les langues disponibles
Translation of original operating instructions
NOTE: Moreover, normal wear and change in product with no functional influence
are not covered by the warranty. Also, be careful that, if the usage
in the instruction manual is not observed as to the mixed gasoline,
etc. described therein, it may not be covered by the warranty.
6.5.
Chain oil
Saw chain adhesive oils of high quality
NOTE: Do not use wasted or regenerated oil that can cause
damage to the oil pump.
7. Operating the engine
WARNING: It is very dangerous to run a chainsaw that mounts broken parts or lacks any
parts. Before starting engine, make sure that all the parts including bar and chain are in-
stalled property.
7.1.
Starting the engine
1. Fill fuel and chain oil tanks respectively and tighten the caps se-
2. Set the switch to "I" position.
3. While holding the throttle lever together with the trigger safety, push
4. Your machine has a primer, press it 3- 4 times to aid starting.
5. While holding the saw unit securely on the ground, pull the starter
WARNING: Do not start the engine while the chain saw hangs in one hand. The chain saw
may touch your body. This is very dangerous.
curely.
(1) Chain oil
(2) Fuel
(1) Switch
in the side latch and release the throttle lever to leave it at the
starting position.
) Choke knob
1
rope vigorously. Press the rear handle down with your foot while
holding the saw unit securely on the ground
NOTE: The Easy-Start device means that during the first third of the
pulling movement there is not yet much resistance on the starter rope
and the engine will not yet start turning only the additional spring is
preloaded which then causes the engine to turn faster as it is pulled
further, resulting in an easy start.
Do not pull out the starter rope completely to the stop. Do not let the
starter handle bounce back against the housing.
11
35
Publicité
