Cross Tools CKS 1200 V Traduction Du Mode D'emploi D'origine page 31

Translation of original operating instructions
2. Explanation of symbols on the machine
ATTENTION: For safe operation and maintenance, symbols are carved in relief on the
machine.
According to these indications, please be careful not to make any mistake.
The port to refuel "MIX GASO- LINE"
Position: Fuel cap
The port to top up chain oil
Position: Oil cap
Setting. the switch to the "l" position, the engine starts.
Setting the switch to the "O" position, the engine stops immediately.
Position: Front at the top of the rear handle
Starting the engine. If you pull out the choke knob (at the back-right of the
rear handle) to the point of the arrow, you can set the starting mode as fol-
lows:
First-stage position starting mode when the engine is warm.
Second stage position starting mode when the engine is cold.
Position: Upper-right of the aircleaner cover
H: The screw under the "H' stamp is The High -speed adjustment screw.
L: The screw under the "L" stamp is The Slow-speed adjustment screw.
T: The screw at the left of the "T" stamp is the idIe adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and ac-
tivated (black arrow).
Position: Front of the chain cover
If you turn the rod by screw- driver follow the arrow to the 'MAX' position, the
chain oil flow more, and if you turn to the 'MIN' position, less.
Position: Bottom of the power unit
3. Technical data
Model
Engine
Motor type
Approval number
Fuel
Chain oil
Engine displacement
Maximum Engine speed at idling
CKS 1200 V
1E39F (EURO V)
e9*2016/1628*2016/1628S
HA1/P*1190*00
Mixture (Gasoline 40:1
Two-stroke oil)
Saw chain adhesive oils of
high quality
37.2 cm³
3,000 ± 200 U/min
5
CKS 1900 V
1E52F (EURO V)
e9*2016/1628*2016/1628SH
B1/P*1192*00
Mixture (Gasoline 40:1
Two-stroke oil)
Saw chain adhesive oils of
high quality
52 cm³
3,000 ± 200 U/min
29