Required Tool And Auxiliaries; The Following Instructions Are To Be Observed Prior To Installation - Hauff-Technik GFH 30 Instructions D'installation

GFH 30
9

Required tool and auxiliaries

For the correct installation of the GFH 30, the following tools and aids are required in addition to
the usual standard tools:
1 Drill for drill hole Ø 30 mm
1 Cartridge gun
1 Hammer
1 Phillips screwdriver
A cartridge gun is required for the correct processing
of the expansion resin (Art. No.: 1920002002). This
can be ordered directly through Hauff-Technik (see
fi g.: 1).
10 The following instructions are to be observed prior to installation of the
wall entry:
WARNING!
Risk of injury in the event of improper installation!
Improper installation can result in signifi cant bodily harm and property damage.
• GFH 30 installation must comply with the relevant professional association
• The nationally applicable laying and fi lling regulations for pipes and cables are
NOTE!
Failure to seal due to incorrect installation!
Improper installation can result in damage.
• Before installing the GFH 30, existing breaks (> 50 mm) in the wall surface or
• All surfaces must be clean, fi rm and free of dust and grease.
• Seal the surface and pipe substructure well prior to laying pipes/cables so that
• No cleaning agents containing solvent may be used to clean the GFH 30. We
• For details of other accessories and further information, see www.hauff-technik.
regulations, VDE provisions, national safety and accident prevention regulations
as well as company regulations (work and procedural instructions).
to be observed at all times.
paint must be properly restored according to DIN 18195 / DIN 18533.
the latter cannot subside.
recommend using cable cleaner KR M.T.X..
de and the technical specifi cation sheets.
Art. Nr.: 5090033079 Rev.: 01/2018-09-04
EN
Fig.: 1
23