GFH 30
Pull the mixer jet out of the fi ller opening with a circular
12
motion (see fi g.: 19).
Cut vent hose to length with a side cutter (see fi g.: 20).
13
14
NOTE!
Failure to seal due to incorrect installation!
Improper installation can result in damage.
• If a SpeedNet tube or electric cable is installed,
only one insertion opening by may be penetrated!
If necessary, penetrate one or both membranes of the
two insertion openings with a suitable tool (e.g. Phillips
screwdriver) (see fi g.: 21).
In order to ensure the SpeedNet tubes or telecommuni-
15
cation lines slide in smoothly, we recommend lubricating
the two SpeedNet tubes/telecommunication lines at the
front with lubricant, e.g. using a lubricant stick (Art. No.:
0804020000) or lubricant tube (Art. No.: 2790009100)
(see fi g.: 22).
Art. Nr.: 5090033079
Rev.: 01/2018-09-04
EN
Fig.: 19
Fig.: 20
Fig.: 21
Fig.: 22
29