MINN KOTA RIPTIDE TERROVA Instructions D'installation page 10

Masquer les pouces Voir aussi pour RIPTIDE TERROVA:

Les langues disponibles

ROUTING THE -PILOT LINK CABLE

Replace the four sideplate screws using a #3 or

#2 Phillips screwdriver. Two of these screws will be

located on each side of the mount.

ROUTING THE i-PILOT LINK CABLE

Your trolling motor may be pre-installed with either i-Pilot or i-Pilot Link. To learn more about the GPS capabilities available with your i-Pilot

or i-Pilot Link navigation system, please refer to the corresponding Owner's Manual by visiting minnkotamotors.com.

The i-Pilot Link features require a cable to be connected to an output device. This connection is present on the trolling motor below the

Control Head, if installed. The i-Pilot system does not need an external wired connection. If only one connection is present, your motor is

equipped with the i-Pilot Link system. If no connections are present, your motor may or may not be installed with i-Pilot. Please follow the

Minn Kota recommendations on routing the cables to optimize mobility and maximize functionality. The routing will be the same regardless

of the number of cables present. Use the following instructions to properly route cables.

Cables are shielded to minimize interference. To protect this

shielding the cables should not be pulled tight against sharp

angles or hard objects. If using cable ties, do not over-tighten.

Any excess cable should be bundled in a loose loop of no less

than 4" in diameter.

To minimize trolling motor interference, ensure that the fish

finder and trolling motor are powered by separate batteries.

Please refer to the Battery & Wiring Installation and Motor

Wiring Diagram sections of this manual for correct

rigging instructions.

10 | minnkotamotors.com

i-Pilot Link Cable

Sideplate Screw

Eight Pin Connector

i-Pilot Link Cable

from Control Head

Locking Collar