MINN KOTA RIPTIDE TERROVA Instructions D'installation page 8

INSTALLING THE RIPTIDE TERROVA
5
ITEM(S) NEEDED
#4 x 6
g. When the motor is in the deployed position, make
sure that the Shaft is 1-1/2" out past the Gunwale of
the boat. The lower unit, when stowed and deployed
must not encounter any obstructions.
h. Check to be sure that the mount is level. Use the
Rubber Washers (Item #4) provided to create a level
surface if necessary.
6
i. It is recommended to mark at least 4 of the 6 holes
in the Base Extrusion and to have a minimum of two
bolts on each side that are located the farthest apart.
Ideal installation would allow for 6 bolts to be used,
with a minimum of 4.
j. Drill through the deck of the boat using a 9/32" Drill
Bit on the marked locations.
8 | minnkotamotors.com
Gunwale
1-1/2"
Minimum
Drilling Locations
Drilling Locations
©2018 Johnson Outdoors Marine Electronics, Inc.
Shaft
Base Extrusion