MINN KOTA RIPTIDE TERROVA Instructions D'installation page 12

INSTALLING THE PROP
INSTALLING THE PROP
1
ITEM(S) NEEDED
#17 x 1
CAUTION
Disconnect the motor from the battery before beginning any
prop work.
a. Take the Drive Pin (Item #14) and slide it through
the Hole in the Armature Shaft. Position the Drive
Pin horizontal by grasping the Armature Shaft and
rotating it with the Drive Pin in place.
b. Align the Propeller (Item #17) so it is also horizontal
and parallel with the Drive Pin. Slide the Propeller
onto the Armature Shaft and Drive Pin until it is
seated against the lower unit.
c. Install the Prop Washer (Item #15) and the Anode
(Item #15) onto the end of the Armature Shaft.
d. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Anode with a 9/16"
Open End Wrench.
e. Tighten the Anode 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Disconnect the motor from the battery before beginning any
prop work.
12 | minnkotamotors.com
#15 x 1
#16 x 1 #14 x 1
1a
Drive Pin
Anode
1b
1d
Anode
Prop Washer
Propeller
Armature
Shaft
Propeller
Prop Nut
Propeller
Drive Pin
©2018 Johnson Outdoors Marine Electronics, Inc.