MINN KOTA RIPTIDE TERROVA Instructions D'installation page 7

2
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the Base
Extrusion.
2c
3
e. Make sure that the Power Cables from the battery are
disconnected, or that the breaker,
if equipped, is "off".
WARNING
Make sure the motor is mounted on a level surface and is not
connected to a power source.
4
f. Place the mount as close to the centerline or keel of
the boat as possible. The motor can be installed on
either the Port or Starboard side of the boat based
on personal preference. Check placement with the
motor in the stowed and deployed positions. Review
the mounting considerations at the beginning of the
installation.
©2018 Johnson Outdoors Marine Electronics, Inc.
Right Sideplate
INSTALLING THE RIPTIDE TERROVA
2d
Base Extrusion
Left Sideplate
Power Cables
Keel
Deck of Boat
minnkotamotors.com | 7