Würth 0772 800 Traduction Des Instructions De Service D'origine page 16

BATTERIE TEST◄ ► ↵
××.×× V
BATTERY TYPE ◄ ► ↵
AGM FLAT PLATE
SELECT RATING ◄ ► ↵
SAE
SET CAPACITY ◄ ► ↵
×××× SAE
Elimination of the surface charge
If the vehicle was running immediately before the test or the battery was charged, the battery probably has
a surface charge. The device may prompt you to remedy this surface charge before the start of the test:
Follow the instructions on the device display:
Battery installed
SURFACE CHARGE
IN VEHICLES? YES
Battery removed
SURFACE CHARGE
IN VEHICLES? NO
The test will be continued as soon as the tester detects that the surface charge has been remedied.
TESTING
IS BATTERY ◄ ► ↵
CHARGED? YES
16
Battery test (example)
Press the ◄ ► key to select battery test. Press Enter.
Press the ◄ ► key to select the battery type:
a. REGULAR LIQUID
b AGM FLAT PLATE
c. AGM SPIRAL
d. VRLA/GEL
Confirm your selection with Enter.
Select the test standard SAE, EN, IEC, DIN or JIS with the ◄ ► keys.
Confirm with Enter.
Press the ◄ ► key to select the battery capacity in CCA
— SAE : 40~2000
— EN : 40~2100
— IEC : 30~1500
— DIN : 25~1300
— JIS : By battery, type, no.
Press Enter to begin the test.
TURN HEADLIGHTS
ON FOR 15 SECS
→
TESTING
→
Test the battery for 5 - 7 seconds.
Select one of the options with the ◄ ► key when the batteries are charged: Yes
or No
Confirm with Enter.