PROTEOR EASY RIDE 1P650 Notice D'utilisation page 14

5. Fit the eight washers and the eight screws provided and apply XC047 medium-strength thread-locking compound. Tighten to
a torque of 0.25 Nm
The screws must be tightened using a torque wrench fitted with a 2 mm hex head bit.
After bonding a cover, the knee must be left to dry for at least 24 h before use.
C. Storage
Service and storage temperature: -25°C to +40°C
Relative humidity of the air: no restrictions
D. Disposal
The various components of this device are considered as special waste: aluminium, stainless steel pins and screws, titanium
connectors, plastic bushes and oil. They must be treated in accordance with current, applicable legislation.
E. Service life
The knee must be serviced after every 100 hours of use by your prosthetist/orthotist (i.e. every year if used at moderate activity levels
or every 6 months at a higher level of activity).
10. DESCRIPTION OF THE SYMBOLS
Manufacturer
11. REGULATORY INFORMATION
This product is a CE-marked medical device that is certified as conforming with regulation (EU) 2017/745
12. NAME AND ADDRESS OF MANUFACTURER
PROTEOR SAS
6 rue de la Redoute – 21850 Saint-Apollinaire – France
Tel.: +33 3 80 78 42 42 – Fax: +33 3 80 78 42 15
cs@proteor.com – www.proteor.com
INSTRUCTIONS FOR USE
Identified risk
CE marking and year of first declaration of
conformity
Page 6 of 6