Technical Data - WAGNER WallPerfect W 995 Traduction Du Mode D'emploi Original

WallPerfect W 995 WallPerfect W 995
Pos. Designation
1 Air hose
2 Securing clip
3 Material hose and control hose *
4 Complete suction hose
5 Air filter cover
6 Air filter (2pcs.)
Lubricating grease
* Denotes parts that can only be purchased together and not individually.

22. Technical Data

Max. viscosity:
Power source:
Power consumption:
Atomizing output:
Max. flow rate:
Double insulation:
Sound pressure level*:
Sound pressure output*:
Oscillation level*:
Air hose length:
Weight:
* Measured in accordance with EN 60745
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can differ from the specified value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
are based on an estimated shutdown during the actual conditions of use (all parts of the
operating cycle are taken into consideration here, for example periods when the electric
tool is switched off, and, when it is switched on but running without any load).
Spare Parts List: W 995 (Fig. A2)
Technical Data
4000 mPas
230 V, ~ 50 Hz
630 W
200 W
525 ml/min
76 dB (A); Uncertainty K = 4 dB
89 dB (A); Uncertainty K = 4 dB
< 2,5 m/s²; Uncertainty K = 1,5 m/s²
3,5 m
5,8 kg
GB D
Order No.
2308 127
2323 071
2314 168
2323 074
2308 132
2310 812
2315 539
41 41