GB
D
Attention! During automatic
cleaning of the pump do not
leave the device unattended. The
hoses could disconnect during
the cleaning operation leading to
water damage.
•
Set the multifunction switch to "FILL/CLEAN".
•
Pull the trigger (fig. 9, 1) and push the stop (2)
upwards to secure the trigger. Allow water to
circulate through the machine for about 10
minutes in order to clean the pump and hoses.
If necessary renew the water.
•
Release the stop by pulling the trigger.
•
Turn the machine off. (Set the multifunction
switch to "OFF")
•
Take the spray lance out of the holder and
remove the cover (fig. 10, 1) from the spray head.
•
Detach the material hose (fig. 10, 2) from the
slot on the spray head.
34
34
WallPerfect W 995
WallPerfect W 995
1
1
2
2