Technical Data; Correction Of Malfunctions - WAGNER W 15 Mode D'emploi D'origine

GB
Descaling
Regular descaling is key to your steamer functioning properly. Depending on
i
water hardness, descale the steam wallpaper remover after 10 – 15 fills.
Devices which are defective due to a lack of descaling are excluded from the
warranty!
•
Use a standard descaling agent (e.g. household vinegar).
Observe the manufacturer's instructions for use!
•
Mix the vinegar with water (ratio 1:1).
•
Fill the steam wallpaper remover with around 2.5 litres of descaling solution.
•
Switch the steam wallpaper remover on for around 10 minutes.
•
Switch the steam wallpaper remover off again and disconnect the mains plug.
•
Leave the descaling solution to work for around 30 minutes..
•
Then fully empty the steam wallpaper remover.
•
Thoroughly rinse the device two to three times with clear water to remove all descaling solution
residue.
Storage
Store emptied, upright and dry.
Regular descaling is key to your steamer functioning properly. Descale the
i
steam wallpaper remover after 10 – 20 hours of operation, depending on the
water hardness. Use a customary descaling agent according to the manufacturer's
specification or household vinegar.
Devices which are defective due to a lack of descaling are excluded from the
warranty!

Technical data

Power source:
Steaming time:
Reservoir capacity:
Weight of the steam bar:

Correction of Malfunctions

Problem
The steam
wallpaper remover
is not working
6
230 -240 V ~
max. 80 min.
4.0 l
145g/190g/240g
Cause
•
Heating element covered in limescale
•
Too little water in tank
•
Device at an angle, heating element is not
in the water
Power consumption:
Steaming power:
Hose length:
Remedy
➞
➞
➞
W 15
2000 W
50 g/min.
3.5 m
Descale
Fill with more water
Move device into
horizontal position