Operation; Standard Operation; Operating With A Somfy Sensor Or Automatic Function; Modifying The Settings - SOMFY HOME MOTION J4 io Notice Installateur

6. OPERATING

6.1. Standard operation

points: Situo mobile io Vb, Easy Sun io, Composio io and Smoove io)

6.1.1. Favourite position (my)

besides the upper and lower positions, an intermediate position known as the "favourite posi-
tion (my)" may be programmed in the motor. The "my" favourite position is pre-set in the
factory, and corresponds to the "slats lowered, sun protection" position.
To modify or delete the favourite position (my), see the section entitled "Modifying settings".
To use the favourite (my) position: Briefly press the "my"
button: the blind starts to move, then stops and angles the
slats in accordance with the angle programmed for the
favourite (my) position.
6.1.2. STOP function
The blind is moving.
Briefly press the "my" button: the blind stops automatically.
6.1.3. Up and Down buttons
A brief press on the Up or Down buttons causes the slats
of the blind to turn.
A long press on the Up or Down buttons will cause the
blind to raise or lower completely.

6.2. Operating with a Somfy sensor or automatic function

Refer to the corresponding manual for the Somfy io sensor.
7. MODIFICATION OF THE SETTINGS
7.1. Favourite position (my)
7.1.1. Modifying the favourite position (my)
• Place the blind in the required new favourite position (my).
• Press the "my" button until the blind moves: the new
favourite position (my) has been programmed.
7.1.2. Deleting the favourite (my) position
• Press the "my" button: the blind will start to move and
will stop in the favourite position (my).
• Press the "my" button again until the blind moves: the
favourite position (my) has been deleted.
© 2011 Somfy SAS. All rights reserved. 112011
(the operation below is only possible with the following control
67