Wiring - SOMFY HOME MOTION J4 io Notice Installateur

Mounting inside the head rail
• The mounting of the J4 io plate inside the head rail is compatible with the following head rails
and shafts:
HEAD RAIL
57 x 51 mm
58 x 56 mm
78 x 67 mm
65 x 64 mm
In order to fix the plate inside the head rail, you may use double sided adhesive tape ref: 9016646.
Mounting the plate with double sided adhesive tape is guaranteed to temperatures from -30°C
to 70°C. However, to ensure proper adhesion over time, it is essential to stick the tape to a
clean surface.

4. WIRING

• Cut off the mains power supply.
This motor must not be connected to an isolati-
on transformer.
Only the io plate ref: 1811130 may be con-
nected to the J4 io motor.
• Connect the motor and plate assembly according to
the information in the table below:
230 V ~ 50 Hz
1
Neutral (N)
2
Live (P) Top
3
-
4
Earth ( )
• A maximum of 3 motors, with a total cable length of
50 m, can be connected in parallel. Live and neutral
must be connected together respectively.
© 2011 Somfy SAS. All rights reserved. 112011
Plate cable
Blue
Black
-
Yellow/Green
Mounting outside the head rail
SHAFT
Up to 14 mm hex
Up to 14 mm square
Up to 14 mm diameter
2
1
4
Plate
Shared
Neutral
Earth
3
Motor
M
63