Mode Of Operation - Meister MAS18V-22 Traduction Du Manuel D'utilisation Original

5451420-Akkubohrsc_man 04.12.14 10:16 Seite 46
an ordinary screwdriver. Always
practise first!
• Starting:
Press the ON/OFF switch (6): The
screwing process will start. Press and
keep the switch during the screwing
process.
• Stopping:
As soon as the screw has been screwed
in or removed fully, release the On/Off
switch.
Selection knob for screwdriver/drill
function (fig. 5)
Use the selection knob for screwdriver/
drill function (1) to select between two
different rotation ranges.
• Switch position
turning screws in and out
• Switch position
screw-driving and drilling
The speed range to be selected is
determined by the respective material
and the planned activity, and is to be
determined through work on a
specimen.
CAUTION! Carry out changeover
with motor stopped only.
9 – Mode of operation
Electronic rotation speed regulation
Using the electronic rotation speed
regulation), you can adapt the rotation
speed continuously to the respective
job.
46
All manuals and user guides at all-guides.com
: 0–350 rpm for
: 0–1000 rpm for
• A light pressure on the On/Off switch (6)
= low revolutions to undo stubborn
screws.
• Hold down the On/Off switch = highest
possible revolutions for drilling.
CAUTION! Avoid the motor coming
to a standstill under loading when
boring or screw-driving!
Clockwise/anti-clockwise run
You determine the rotation direction with
the aid of the slide switch (3) above the
On/Off switch.
PLEASE NOTE! Change rotation
direction only with motor
stopped!
• Screw-driving in bolts: Slide switch to
Position R.
• Turning off bolts: Slide switch to
Position L.
• Safety position: Switch middle
position; in this position of the slide
switch the device cannot be put into
operation, e.g. in case of work
breaks, bit or drill change.
Torque setting
The screwdriver/drill has a 23-level
torque setting (8) designed to prevent