Charging Battery - Meister MAS18V-22 Traduction Du Manuel D'utilisation Original

5451420-Akkubohrsc_man 04.12.14 10:16 Seite 44
• Protect the charger and the screw -
driver from contact with moisture.
Never immerse in water!
• Do not use the charger in the open air.
• To avoid damage to the batteries,
never expose them to temperatures of
over 50 °C.
CAUTION! Do not short-circuit the
contacts of the battery or charger.
• When charging, ensure that the
device is correctly connected („+/–").
• Do not attempt to burn the battery.
• The connection cord cannot be
replaced. In case of damage, dispose
of the device in the correct manner. In
case of damage, dispose of the
device in the correct manner.
Safety marking
The symbols on the housing mean the
following:
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
„Tested Safety" voluntary
quality mark
CE Mark (conformity to
European safety standards)
7 – Charging battery
CAUTION! This cordless
screwdriver MAS18V-22 may
44
only be charged using the charger
All manuals and user guides at all-guides.com
XR-DC240400B. The charger may only
be operated with a power supply that
has an alternating current of 220–
240 V and a frequency of 50 Hz. Any
use of any other charger or the
charger XR-DC240400B connected to
a power supply other than the one
listed may lead to personal injury and
damages.
The battery packs (4) are not fully
charged at the factory and must be
charged prior to initial use.
To do this, remove the battery pack (4)
from the cordless drill/screwdriver
(Figure 2).
Connect the charging plug (10) of the
mains adapter (9) with the charger (11)
and connect the mains adapter to a
socket (230 V~). (Figure 3)
The red control lamp will light up as
soon as contact is made with the power
supply.
Fit the charger (11) to the battery
pack (4) while paying attention to ensure
that the poles (+/-) are correct.
The green control lamp will light up
when electrical contact is made.
IMPORTANT! If a recently used
up battery is inserted and the
green control lamp does not light
immediately, remove the battery and
start the charging process again a
few minutes later.
The normal charging time is around
3-5 hours. Then press the unlocking
button on the battery pack (4) and
remove the battery pack from the charger.
IMPORTANT! The warming of the
charger and battery during the