Stryker AIM SafeLight Mode D'emploi page 16

Steris/Amsco V-PRO
1. Clean and prepare the device as recommended in this user manual.
2. If using a sterilization tray, follow any additional instructions provided with
the tray. Use only trays that are approved for sterilization with Steris/Amsco
V-PRO.
3. Double wrap the device (or tray) prior to sterilization.
4. Sterilize the device using one of the following V-PRO sterilization systems:
• V-PRO 1 Sterilizer (Standard cycle)
• V-PRO 1 Plus Sterilizer (Non-Lumen or Standard cycle)
• V-PRO maX Sterilizer (Non-Lumen or Standard cycle)
5. Allow the cable to cool to room temperature before reuse.
Sterrad
1. Clean and prepare the device as recommended in this user manual.
2. If using a sterilization tray, follow any additional instructions provided with
the tray. Use only trays that are approved for sterilization with Sterrad 100S,
200, NX, or 100NX.
3. Double wrap the device (or tray) prior to sterilization.
4. Following the instructions of the manufacturer, sterilize the device using
the Sterrad 100S, 200, NX, or 100NX system. Select the standard cycle.
5. Allow the cable to cool to room temperature before reuse.
Maintenance
Inspection
• Inspect the device on a continual basis. If you observe or suspect a problem, return
the device for evaluation and possible repair.
• Inspect all components for cleanliness. If fluid or tissue buildup is present, repeat
the above cleaning and sterilization procedures.
Storage
Store the device in a dry, clean, and dust-free environment at room temperatures.
Expected Service Life
The expected service life of the cable is 100 reprocessing cycles (one year based on
two cases per week). When the device has reached the end of its service life, dispose of
it according to local laws and hospital practices.
EN-12