Oven Racks; Probe; Oven Bottom - Monogram ZDP364 Manuel D'utilisation

Cuisinières au gaz naturel ou au propane professionnelles
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CARE AND CLEANING

OVEN RACKS

NOTE: The racks may remain in the oven during the self-
cleaning cycle without being damaged.
Periodically, the oven racks may need to be lubricated
using the Graphite Lubrication shipped with your range.
To order additional Graphite Lubrication, call our National
Parts Center at 800.626.2002 and reference WB02T10303.
1. Remove rack from the oven. See the Full extension
oven racks section.
2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the rack for
easy cleanup.
3. If there is debris in the slide tracks, wipe it away using a
paper towel. NOTE: Any graphite lubricant wiped away
must be replaced.
4. Shake the graphite lubricant before opening it. Starting
with left slide mechanism of the rack, place four (4)
small drops of lubricant on the two (2) bottom tracks of
the slide close to the bearing carriers.

PROBE

Allow the temperature probe to cool before cleaning.
The probe should be cleaned with soap and water by hand.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Do not clean the temperature probe in the self-cleaning oven.

OVEN BOTTOM

The oven bottom has a porcelain enamel finish. To make
cleaning easier, protect the oven bottom from excessive
spillovers. A smaller sheet of foil or sheet tray may be used
to catch a spillover by placing it on the rack below the rack
you are cooking on. This is particularly important when
baking a fruit pie or other foods that are highly acidic. Hot
fruit fillings or other foods that are highly acidic (such as
tomatoes, sauerkraut and sauces with vinegar or lemon
juice) may cause pitting and damage to the porcelain
enamel surface and should be wiped up immediately.
49-2000877 Rev. 3
Right side
5. Repeat for the right slide mechanism of the rack.
Rack right-side-up
6. Open and close the rack several times to distribute the
lubricant.
7. Replace the cap on the lubricant and shake it again.
Turn the rack over and repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up and place in the
oven. See the Full extension oven racks section.
9. Repeat above steps for each rack.
NOTE: Do not use a cooking spray or other lubricant
sprays on the slides.
Never fully cover a rack with aluminum foil. This will disturb
the heat circulation and result in poor baking.
To clean up spillovers, use soap and water, an abrasive
cleaner or soap-filled scouring pad. Rinse well to remove
soap before self-cleaning.
Rack right-
side-up
Left side
41

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zdp484

Table des Matières