Level The Range; Replace Oven Door(S) - Monogram ZDP366NTSS Instructions D'installation

10

LEVEL THE RANGE

WARNING
The range must be level and be
supported by the legs—not the wheels. The range could
move if the wheels make contact with the floor. Be sure
all legs make contact with the floor in any installation.
■ A ll legs must be leveled after the product is installed.
■ C heck to be sure the adjoining cabinets/countertops
are level, front to back and left to right across the
opening of the range.
■ M easure the distance from the floor to the top of the
countertop in the left and right rear corners.
■ A djust the height of the range to countertop height
or higher.
IMPORTANT: This range should always be installed
at countertop height or higher. DO NOT INSTALL THE
RANGE LOWER THAN ADJACENT COUNTERTOP
HEIGHT. The range must be supported by all 4 legs,
regardless of countertop height.
FRONT LEG ADJUSTMENT
■ A leveling leg wrench is supplied. Reach under the
front of the range near the right leg. Locate and
remove a thumb screw, then slide wrench out of
the slot.
■ S lide front cylinders up to access front leveling legs.
Be careful not to damage cylinder.
Thumb Screw
■ U se the supplied wrench to adjust the front leveling
legs. Turn clockwise to extend the legs to lift and
stabilize the range. Turn counterclockwise to retract
the legs and allow the range to rest on its rollers.
■ B e sure to return the wrench to its storage slot for
future use.
16
Installation
10
REAR LEG ADJUSTMENT
WARNING
shock, always replace the spill plugs in the leveling
rod holes.
■ R emove two screws from rear vent trim. Slide vent
trim forward, then lift up to remove.
■ R emove the 2 spill plugs to locate the rear leg
extension leveling rods. Use a 1/4" driver or socket
wrench to adjust the left or right rear legs.
■ F ind the two rear leg extension rods. Use a 1/4" driver
or wrench to adjust the left or right rear legs.
■ R eplace the 2 spill plugs and then replace the rear
vent trim using the original screws.
11
Skip this step if oven doors are in place.
IMPORTANT: Do not lift the door by the handle.
To replace the oven doors:
■ Firmly grasp the door at the top sides. This is critical.
■ A pproach the range with the door angled in a
vertical position.
Slide leg
■ G uide the hinges into the slots.
cylinder up.
■ P ush the door in firmly while opening.
■ O nce in position, open the door completely. Push
the hinge locks back in toward the front frame.
CAUTION
doors. If the hinge latch
is not securely locked,
the hinge may snap back
and separate. If the hinge
separates, you must apply
pressure (possibly with
your foot) to press it back
together and then engage
the hinge latch.
LEVEL THE RANGE (cont.)
To reduce the risk of fire or electric
Spill Plugs

REPLACE OVEN DOOR(S)

Take care when replacing the oven
Rear Leg
Extension
Rods
31-2000667 Rev. 1