Oven Door - Monogram ZDP364 Manuel D'utilisation

CARE AND CLEANING
LIFT-OFF SOFT-CLOSE OVEN DOOR
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down
toward the door frame, to
the unlocked position. A tool,
such as a small flat-blade
screwdriver, may be
required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the
door removal position,
(approximately 15 degrees
from closed) and lift it up and
out until the hinge arm is clear
of the slot.
CLEANING THE OVEN DOOR
Cleaning the Door Interior
Do not allow excess water to run into any holes or slots in
the door .
Wipe dish soap over any baked-on spatters on the glass.
Use a single sided safety razor blade to clean it off. Then
wipe over the glass with a soapy cloth to remove any
residue and dry off.
The area outside the gasket can be cleaned with a
soap-filled plastic scouring pad. Do not rub or clean
the door gasket - it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn, frayed or damaged
in any way or if it has become displaced on the door, you
should have it replaced.
42
Slot
Hinge lock
Pull hinge locks down to unlock
Removal
position
To replace the door:
1. Firmly grasp both sides of
the door at the top.
2. With the door at the same
angle as the removal position,
seat the indentation of the
hinge arm into the bottom
edge of the hinge slot. The
notch in the hinge arm must
be fully seated into the bottom
of the slot.
3. Fully open the door. If
the door will not fully
open, the indentation is
not seated correctly in
the bottom edge of the
slot.
4. Push the hinge locks up
against the front frame
of the oven cavity, to the locked position.
5. Close the oven door.
Cleaning the Door Exterior
If a stain on the door vent trim is persistent, use a mild
abrasive cleaner and a sponge-scrubber for best results.
Do not use this method on any other surface.
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface. To
clean the stainless steel surface, use warm sudsy water or
a stainless steel cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the cleaner instructions
for cleaning the stainless steel surface. To inquire about
purchasing cleaning products including stainless steel
appliance cleaner or polish, see the Accessories and
Consumer Support sections at the end of this manual.
Replacement
position
Bottom
Hinge arm
edge of
slot
Indentation
Hinge
arm
Hinge
lock
Push hinge locks up to lock
49-2000877 Rev. 3