Electronic Speed Control (Esc); Powering On The Vehicle; Performing A Control Direction Test - Horizon Hobby LOSI 1969 CAMARO Manuel D'utilisation

ELECTRONIC SPEED CONTROL (ESC)

CONNECTING
1. Connect the ESC EC3 Connector to the EC3 Battery Connector
CALIBRATING
Ensure proper ESC function by calibrating the ESC to your transmitter inputs.
1. Power OFF the ESC.
2. Ensure your transmitter is powered ON, the throttle is not reversed, the throttle trim is
neutral and the throttle travel range is at 100%.
3. Keep the throttle at neutral and power ON the ESC.
4. The ESC automatically calibrates the throttle range after 3 seconds.
5. One long beep will sound when the ESC is ready to run.
PROGRAMMIN
G
The ESC comes with a jumper pre-installed in the position for NiMH batteries.
To change the battery type:
1. Power OFF the ESC.
2. Disconnect the jumper from the default port and connect it to the desired port.
3. Power ON the ESC.
If the jumper are lost or not installed, the ESC will default to Ni-MH.
WARNING: Do not connect bind plugs or receiver servo leads into the ESC
programming port. Doing so may damage the ESC and/or components.

POWERING ON THE VEHICLE

1. Power on the transmitter.
2. Remove the body from the vehicle.
3. Connect a fully charged battery pack to the ESC.
4. Power on the ESC.

PERFORMING A CONTROL DIRECTION TEST

Perform a control test with the vehicle wheels off the ground. If the wheels rotate after the
vehicle is powered ON, adjust the throttle trim until they stop. To make the wheels move
forward, pull the trigger. To reverse them, wait for the wheels to stop, then push the trigger.
When moving forward, the wheels should maintain a straight line without any steering wheel
input. If not, adjust the steering trim, so the wheels maintain a straight line without having to
turn the steering wheel.
'69 CAMARO 1:10 4WD RTR • INSTRUCTION MANUAL
NOTICE: Always disconnect the battery from the ESC when you have finished operating
your vehicle. The ESC's switch only controls power to the receiver and servos. The ESC will
continue to draw current when connected to the battery, resulting in possible damage to
the battery through over-discharge.
Battery Mode
Selection
Servo Port
Servo Port
Y Harness
Battery Mode Selection
NiMH
EN
Servo
Lights
LiPo
5