Yamaha YZ450F Manuel D'atelier Du Proprietaire page 530

a
1
2
HANDLEBAR
9. Install:
• "ENGINE STOP" button 1
• Clutch lever holder 2
• Bolt (clutch lever holder) 3
• Hot starter lever holder 4
• Bolt (hot starter lever holder) 5
• Clamp 6
NOTE:
• The "ENGINE STOP" button, clutch lever
holder and clamp should be installed accord-
ing to the dimensions shown.
• Pass the "ENGINE STOP" button lead in the
middle of the clutch lever holder.
10. Install:
• Clutch cable 1
• Hot starter cable 2
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
11. Adjust:
• Clutch lever free play
Refer to "CLUTCH ADJUSTMENT" sec-
tion in the CHAPTER 3.
• Hot starter lever free play
Refer to
ADJUSTMENT" section in the CHAPTER
3.
12. Clamp the clamp portion a of the number
plate to the handlebar.
13. Insert the end of the fuel breather hose 1
into the hole in the steering shaft cap 2.
5 - 47
CHAS
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
"HOT STARTER LEVER