Installation (Expert Personnel); Notes Of The Installation - Pluggit Avent AP190 Manuel D'utilisation Et D'installation

22
23
24
25
26
A version
22 Temperature sensor
exhaust air (T3)
23 Humidity and VOC sensor
(accessories)
24 Connection pressure
sensor exhaust air (T3)
25 Connection pressure
sensor supply air (T2)
26 Temperature sensor
supply air (T2)
27 Temperature sensor
outside air (T1)
28 ---
29 Connection pressure
sensor outside air (T1)
30 Connection pressure
sensor outgoing air (T4)
31 Temperature sensor
outgoing air (T4)
8
OII Avent P190/P310/P460
27
28
29
30
31
M+P-26A-0832
B version
Temperature sensor
outside air (T1)
---
Connection pressure
sensor outside air (T1)
Connection pressure
sensor outgoing air (T4)
Temperature sensor
outgoing air (T4)
Temperature sensor
exhaust air (T3)
Humidity and VOC sensor
(accessories)
Connection pressure
sensor exhaust air (T3)
Connection pressure
sensor supply air (T2)
Temperature sensor
supply air (T2)

4. INSTALLATION (EXPERT PERSONNEL)

Warning:
The installation of the room ventilation unit must
only be carried out by qualified personnel, since
damage or injury may otherwise result.
Warning:
To protect the unit from dirt and humidity, all open-
ings must be sealed until the commissioning, e.g.
by a plaster protection.

4.1. NOTES OF THE INSTALLATION

• The room ventilation unit can be installed in dry rooms
with temperatures above 12 °C, such as the utility room.
Note:
If the temperature decreases below 12 °C in the instal-
lation room there can be condensation in the device
enclosure.
• Position the room ventilation unit in such a way that the
outside and outgoing air lines can be led outside the
house by the shortest route.
• The vibrations of the room ventilation unit must be
damped. The room ventilation unit must be installed in a
sound-decoupled manner.
• The room ventilation units Avent P190/ P310 are
installed using a wall rail.
• The room ventilation unit Avent P460 and optionally the
Avent P310 are installed using a wall bracket.
• The room ventilation unit must be freely accessible for
all maintenance and repair work.
• The correct settings of the air volume flows according to
DIN 1946 part 6 must be observed.
• Do not start running the room ventilation unit before all
installation work is completed.