Pluggit Avent AP190 Manuel D'utilisation Et D'installation page 15

5
3. Place fittings (5) (accessory) in the floor air connection
and tighten with screws (6) if necessary.
4.3.2. Installing Avent P190/P310
1
1. Glue rubber buffer (1) on the back of the room ventilation
unit (2).
Note:
When using the spacers, employ the delivered rubber
buffers. Use greater rubber buffers (1) for Avent P190.
Choose screws (3) with fitting dowels in accordance with
the masonry.
6
6
M+P-26A-0932
2
M+P-26A-0835
2. Fit the room ventilation unit (2) into the wall rail (3).
3. Check horizontal and vertical positioning of the room
ventilation unit (2) using a spirit level.
4. Place IsoPlugg insulating ducts for outside and outgoing
air or silencer for supply and exhaust air on corre-
sponding fitting (4).
2
3
3
2
M+P-26A-0836
4
M+P-26A-0933
13
OII Avent P190/P310/P460