Switching On/Off Preset Weekly Programme Or Automatic Programme; Selecting Ventilator Level Manually; Switching On And Off Fireplace Feature - Pluggit Avent AP190 Manuel D'utilisation Et D'installation

5.4. SWITCHING ON/OFF PRESET WEEKLY
PROGRAMME OR AUTOMATIC PROGRAMME
You can choose between a total of 10 preset weekly pro-
grammes or one automatic programme.
Note:
One preset weekly programme or the automatic
programme must be selected when commissioning the
unit, see page 19.
About control unit
1
Preset weekly programme:
Briefly press button (1).
The LED (2) is illuminated and the preset weekly pro-
gramme is switched on.
Automatic programme:
Press button (1) for approx. 10 seconds.
The LED (2) flashes and the automatic programme is
switched on.
About Pluggit iFlow
1. Activating Pluggit iFlow, see page 36.
2. Follow the instructions of the Pluggit iFlow and switch
on or off the preset weekly programme or automatic
programme.
38
OII Avent P190/P310/P460
2
M+P-26A-0900

5.5. SELECTING VENTILATOR LEVEL MANUALLY

You can choose between ventilator level 0-4. The ventilator
level 0 is a stand-by mode and can be turned on for a
maximum of 1 hour.
The ventilator level 4 can only be turned on for a maximum
of 4 hours.
After the time has expired, the room ventilation unit auto-
matically switches back to the last operating mode.
About control unit
1
2
Repeatedly press button (1) until the desired ventilator level
is selected.
Depending on the selected ventilator level, the corre-
sponding number of LEDs (2) is illuminated.
About Pluggit iFlow
1. Activating Pluggit iFlow, see page 36.
2. Follow the instructions of the Pluggit iFlow and select
ventilator level.

5.6. SWITCHING ON AND OFF FIREPLACE FEATURE

If an indoor air dependent and an indoor air independent
fireplace, such as a fireside, exist, the fireplace feature
must be switched on.
If the outgoing air temperature falls below 3 °C, the room
ventilation unit switches off for 4 hours. After the time has
expired, the room ventilation unit automatically turns on
again.
About Pluggit iFlow
1. Activating Pluggit iFlow, see page 36.
2. Follow the instructions of the Pluggit iFlow and switch
on or off the fireplace feature.
M+P-26A-0901