Activating Pluggit Iflow; Setting The Time; Switching On/Off Installer Menu - Pluggit Avent AP190 Manuel D'utilisation Et D'installation

4.6.2.

Activating Pluggit iFlow

Settings for the commissioning and the handling of the
room ventilation unit can be made using the Pluggit iFlow.
Note:
The Pluggit iFlow can be downloaded free of charge at
www.pluggit.com and installed on the laptop. For this
purpose, you need to register as user/specialised
company.
1. Remove designer cover (1).
2
2. Start laptop.
1
M+P-26A-0935
M+P-26A-0848
3. Plug the USB cable with port type A in the laptop and
port type B in USB interface (2).
4. Start Pluggit iFlow.
5. Open installer section using the password.
The password is available after successful registration.
6. If the room ventilation unit is not automatically detected,
enter serial number and save it, see page 27.
7. Select the desired settings in Pluggit iFlow and follow
the instructions.
4.6.3.

Setting the time

About Pluggit iFlow
1. Activating Pluggit iFlow, see page 17.
2. Follow the instructions of the Pluggit iFlow, compare
time to that on the laptop and set time if necessary.
4.6.4.

Switching on/off installer menu

About control unit
1
3
2
Switching on
Simultaneously press buttons (1) and (2) for approx.
10 seconds until LEDs (3) start flashing.
The installer menu is switched on and the ventilators
accelerate to level 3.
All other device features are disabled.
Switching off
Simultaneously press buttons (1) and (2) for approx.
10 seconds until LEDs (3) turn off.
The room ventilation unit runs in the last operating mode.
M+P-26A-0892
17
OII Avent P190/P310/P460