Service And Disassembly; Disassembly Instructions - Franklin Electric MH Serie Mode D'emploi

MH Series Horizontal Multi-stage Pump
Draining
WARNING
s
WARNING
!
to prevent damage from freezing, remove the drain plug from the pump case.
While this will drain the pump, it will not necessarily drain all other parts of the piping system. If
there are any concerns with the proper procedure or necessity of draining the suction plumbing,
contact your contractor.
All piping and water tanks exposed to freezing weather should be drained. If there are any concerns
with the proper procedure to drain the system's pressure tank, contact the tank manufacturer for
assistance.

Service and Disassembly

s
WARNING
!

Disassembly Instructions

If you experience problems with your pump, determine the possible causes
s
NOTICE
!
from the service check list. (TROUBLESHOOTING) Follow the steps below to
disassemble the pump. Reassemble in reverse order. Clean the seals and the sealing surfaces in the
pump case. Lightly lubricate the rubber part of the seals with silicone grease to aid in assembly. DO
NOT lubricate the carbon or ceramic faces on the shaft seal.
10
Before disconnecting pump, be sure fuse box leads are disconnected
or power is turned off. After reassembling the pump, refer to priming
instructions before running. If your pump must be drained for service or
Before disconnecting pump, be sure fuse box leads are disconnected or power
is turned off at the breaker box. After reassembling the pump, refer to priming
instructions before running.
Drain Plug