Table des Matières
Publicité
INSTALL THE NEW TRANSPORT WHEEL BRACKETS
4. Install the two new transport wheel brackets to the two legs
on the footbar end of the machine. Near the tip of the leg, you
will find holes to match the two holes in the brackets. Install
the brackets so that the screws are towards the center of the
machine and the protruding flange is towards the outside of
the machine (see photo below). Fasten the brackets to the leg
with the 3/4" black button head allen screws and the nylock
nuts. Use a 7/16" wrench to hold the nut on the inside of the
leg while you tighten the screw with the small Allen wrench.
INSTALL THE RED WHEELS ONTO THE NEW
TRANSPORT WHEEL BRACKETS
5. Using the two 1/2" wrenches, loosen and remove the nut on
the bolt that holds the red transport wheels to the old bracket.
Watch for washers and observe where they are placed so that
you can replace them correctly when you fasten the wheels
to the new brackets. Leave the old transport wheel brackets
in place as they provide attachment points for the foot
strap. Install the wheels on the inside of the transport wheel
brackets. See Figure A.
Fig. A
20
INSTALL THE SHOULDER POSTS
6. With assistance, return
the Allegro to the upright
position. Under the
shoulder rest you will see
two silver-colored screws
that lock the shoulder rests
into place on the carriage.
Using the large flat head
screwdriver, remove the
screw furthest from the
pad. See Figure B. Remove
the spacer between the
screw and the bottom of
the bracket. Set aside.
7. Install the provided 1 - 1/4"
long silver screws. Be sure
to replace the spacers.
Tighten these screws
firmly. Finish by turning
the shoulder rest over and
screwing the black post
onto the exposed threads
of the new screw. See
Figure C. Grip the posts
firmly and tighten them as
much as possible.
8. Repeat on other shoulder rest.
Fig B
Fig C
Publicité
Table des Matières
