Signal Cable Connection; Video Cable Connection; Telemetry Lines Connections - Videotec ULISSE COMPACT Manuel D'instructions

7.3.3 Signal cable connection

All signal cables must be grouped together
by means of a strap.
Fig. 14

7.3.3.1 Video cable connection

CDS installation type (Cable Distribution
System). The installation is type TNV-1, do
not connect it to SELV circuits.
CAUTION! In order to reduce the risk of fire,
only use cable with sections greater than or
equal to 0.13mm² (AWG 26).
The content of this chapter does not apply
to the versions with digital video encoder.
The video signal is present on connectors J5 and J7 of
the board. Only use one connector.
Connector J5: Connect the screen and the central
cable to terminals GND and CVBS respectively.
Connector J7: Connect the coaxial cable to the BNC
connector (not supplied) and then connect it to
connector J7.
The terminals accept cables with sections between
1.5mm² (AWG16) and 0,5mm² (AWG30).
Fig. 15
16

7.3.3.2 Telemetry lines connections

CDS installation type (Cable Distribution
System). The installation is type TNV-1, do
not connect it to SELV circuits.
CAUTION! In order to reduce the risk of fire,
only use cable with sections greater than or
equal to 0.13mm² (AWG 26).
The content of this chapter does not apply
to the versions with digital video encoder.
The product is supplied with 2 RS-485 serial
communication lines.
TELEMETRY LINES CONNECTIONS
Serial line Terminal
RS-485-1 A (+)
B (-)
SGND
RS-485-2 A (+)
B (-)
SGND
Tab. 3
The lines can be configured in various ways according
to the positions of dip-switches 5 and 6 on the Serial
(DIP 1) of the CPU board (7.6.5 Setting of the serial
communication lines, page 21).
Fig. 16
Description
RS-485 line (1)
RS-485 line (1)
RS-485-1 line
reference
RS-485 line (2)
RS-485 line (2)
RS-485-2 line
reference
MNVCUCZ_1511_EN