Connecting The Power Supply (Poe+); Connecting The Power Supply (Version Of The Product Cabled); Connecting The Power Supply (24Vac/24Vdc); Connection Of The Ethernet Cable - Videotec MAXIMUS MMX Manuel D'instructions

4.3.1.2 Connecting the power supply (PoE+)

The Ethernet cable shield must always be
earthed via the connector. Always use a
shielded RJ45 connector.
The product can be powered using PoE+ (Power Over
Ethernet) devices in compliance with international
standard for technological information IEEE 802.3at,
with the help of an Ethernet data cable of Category
5E (or higher).
The Ethernet cable should be connected to
connector RJ45 of the housing board (J8, 4.2 Housing
board description, page 6).
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B).

CONNECTION OF THE ETHERNET CABLE

Pin number Cable colour
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 3
MNLCMMXCAM_1905_EN
4.3.2 Connecting the power supply
(version of the product cabled)
4.3.2.1 Connecting the power supply (24Va
c/24Vdc)
Perform the connections following the instructions
reported in the table .

CONNECTING THE POWER SUPPLY (24VAC/24VDC)

Colour
Black 1
Black 2
Tab. 4
4.3.2.2 Connecting the power supply (PoE+)
The product can be directly connected to an
Ethernet switch equipped with a PoE+ (End-Span
configuration) port or a classic Ethernet switch using
a PoE Injector (Mid-Span configuration).
Function
~/+
~/-
7