Washing System Connection; Connection Of The Ethernet Cable - Videotec ULISSE COMPACT Manuel D'instructions

The light sensitive switch is especially
useful in areas where brightness varies
greatly.
When the illuminator switches on, the
camera automatically switches to Night
Mode.
For further details on configuration and use refer to
the relative chapter (9.1.9.11 Advanced Setting Menu
(Infrared), page 35).
The light sensitive switch must be connected
between terminals A5 and G of the alarm board light
sensitive switch dry contact).
Fig. 21
Characteristics of the light sensitive switch (not
supplied as standard): Dry contact output and
sensitivity range comprised between 1 and 100 LUX,
normally open.

7.4.5 Washing system connection

For further details on configuration and
use, refer to the relative manual.
When the washing system is enabled, the
relay 2 is used exclusively for the activation
of the pump (9.1.13 Washer Menu, page 43).
MNVCUCZ_1511_EN

7.4.6 Connection of the Ethernet cable

Operating mode valid only on version with
IP board.
Telemetry and video signal transmission
pass through the Ethernet network cable.
Do not connect cable RS-485 and the video
cable.
Connect the J3 connector of the secondary connector
board using a 5E category, or higher, shielded cable (
7.4.1 Description of the secondary board, page 17).
The example below shows a typical installation.
Personal
Computer
Fig. 22
Hub / Switch
19