Cleaning And Storage - Cleanmaxx SLX225C Mode D'emploi

EN
4. Switch on the device using the On / Off switch. The device will start vacuuming
immediately.
5. Move the device over the area which is to be cleaned.
6. Switch off the device using the On / Off switch after you have fi nished vacuum
cleaning.

Cleaning and Storage

ATTENTION!
■ Make sure that the device is switched off before cleaning it.
■ Never immerse the motor unit, mains adapter or manis cable in water or other liquids.
■ The device must not be connected to the mains adapter during cleaning of the coll-
ecting container.
■ Never use soap or other cleaning products for cleaning the dust fi lter. This would
cause damage to the dust fi lter.
■ Only reassemble the device once all of the parts are completely dry!
■ Do not use any corrosive or abrasive cleaning agents to clean the housing. They
could damage the surfaces. If necessary, clean the housing using a slightly damp,
soft cloth.
Emptying the Collecting Container and Cleaning the Dust Filter
1. Hold the device fi rmly by the handle and keep it as horizontal as possible.
4. Empty the collecting container into a rubbish bin. Tap the dust fi lter out over the
rubbish bin.
5. If necessary, clean the collecting container and dust fi lter with clear, lukewarm water.
6. Let all parts dry completely before you put them back together.
ATTENTION: Never insert the dust fi lter while it is still damp.
The device is assembled in the reverse order.
20
2. Press the release button and remove the collecting
container.
3. Remove the dust fi lter from the collecting container.