Operation; Normal Pump Operation Mode; Test Operation; Switching The Pump Off - Ecolab EMP Kompakt II DN20 Manuel D'utilisation

8

Operation

Personnel:
Read the User Manual for the EMP II E60 diaphragm metering pump,
Article No. 417101795
Additional safety measures are not required when using metering media in
accordance with DVGW worksheet W 504.
DANGER!
Personal protective equipment, hereinafter referred to as PPE, is used to
protect personnel. It is imperative to pay attention to the PPE described in
the product data sheet for the metered medium.
8.1

Normal pump operation mode

EMP Compact DN20 and DN25:
After one external pulse from the water meter (DIV n = 1),
the pump performs a stroke.
EMP Compact DN40:
After two external pulses from the water meter (DIV n = 2),
the pump performs a stroke.
NOTICE!
With every stroke, the display in top right of the screen rotates
Take note of the maximum pulse sequence that can be processed!
8.2

Test operation

[Test] Keep the key pressed.
ð While the
water meter. This can be used for bleeding the suction line manually
Ä Chapter 7.3 'Bleeding the metering pump' on page 36.
8.3

Switching the pump off

[Keep the START/STOP] button pressed for approximately 5 seconds.
ð The display goes blank, and the metering pump is switched off.
n Specialist
n Operator
Ä Chapter 3 'Scope of supply' on page 20.
[Test] button is pressed, the pump runs without pulses from the
41
Operation
.
417101964 Rev. 4-04.2019