Installing The Control Unit - Sentiotec infrabox Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation instructions, for professionals only

4.2. Installing the control unit

The control unit 2 of the infrared controller is installed on the outside wall of the
cabin with a maximum clearance of 10 metres from the power supply unit 1 (see
Fig. 2). For the installation, a standard jigsaw is required to cut out the recess for
the control unit. The control unit can be installed both inside and outside the cabin.
* For installing inside an infrared cabin, a minimum clearance of 30 cm
must be maintained (see Fig. 2 Control unit position on page 11).
ATTENTION!
Damage to the unit
● The control unit 2 of the infrared controller is splashproof (protection
class IP X4).
● Work on the control unit must only be carried out using a standard screwdriver.
Using a cordless screwdriver may cause irreparable damage to the housing.
1
min. 30 cm
Control
2
unit
Fig. 2 Control unit position
* for assembly inside the cabin
Power unit
Infrabox
*
External view
p. 11/44
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Infrabox white

Table des Matières