Connecting The Device - Sentiotec wave.com4 sound Instructions De Montage Et Mode D'emploi

Instructions for use

4.2. Connecting the device

Note Fig. 1.
1. Plug the 2-pin connection cable into the terminals labelled "Netzteil - rot
schwarz". It is NOT necessary to use correct polarity.
2. Plug the cable of the right speaker into the terminals labelled "LS rechts",
the cable of the left speaker into the terminals labelled "LS links":
● Plug the red cable into the terminals labelled "+" and the black cable
into the terminals labelled "-".
Detaching the cables (see Fig. 1)
1. Insert a screwdriver through one of the three round openings on the
back of the device.
2. Press the screwdriver on the terminal in question while pulling gently
on the cable.
3. If you want to use an audio system for music playback, connect the line-out
output of the Bluetooth module to the line-in jack (aux-in jack) of the audio
system. To do this, use a cable that is temperature resistant to 150 °C and
has 3.5 mm jack plugs.
Line-out
output
Terminals for
the speaker
on the right
Fig. 1: Connecting the device (rear view)
WORLD OF WELLNESS
p. 8/18
Detaching
the cables
Terminals for the
speaker on the left
Terminals for the
connection cable