Press NO if no leak was found, upon completion of the PRE-CHARGE TEST, the system will go
on to charging with the present quantity of refrigerant .
Then the following screen will be displayed.
Disconnect HP coupling. Start A/C system with LP coupling connected, press ENTER
NOTE: During this phase the message "Please wait" may appear on the screen, its duration
is a function of the A / C pressure and can last for a maximum of 1 minute
The A/C system will recover the refrigerant into the service hoses, then the following screen will
be displayed:
Disconnect LP coupling from A/C system, then press ENTER to continue:
INSTRUCTIONS MANUAL
Was a leak found?
YES
0g
CHARGE AMOUNT
CHARGE
Gas charged:
Tank Pressure
A/C pressure
Tank Temperature
Disconnect HP coupling Start A/C system with LP
coupling connected end press ENTER
Disconnect LP coupling from A/C system end press ENTER
-53-
DD/MM/YY XX:XX PM
NO
0g
CHARGE AMOUNT
DD/MM/YY XX:XX PM
86g / 100 g
6.6 bar
STOP
2.9 bar
25.5 °C
DD/MM/YY XX:XX PM
ENTER
DD/MM/YY XX:XX PM
ENTER