Start Procedure - Mopar ECO NEXT ONE Manuel D'instruction

START PROCEDURE

After selected all the procedure data, press ENTER to continue, the following screen will be
displayed:
Connect and open the coupling connected to the A/C system, then press ENTER, press ESC to
return back.
Open manual valves and press ENTER.
If the vacuum is not sufficient, this screen will be displayed:
Then run a VACUUM procedure.
Instead with sufficient VACUUM the machine will proceed to inject the amount of oil set
Subsequently the machine will proceed with the quantity of gas set
INSTRUCTIONS MANUAL
Connect and open HP and LP couplings
to A/C system and press ENTER
Open HP and LP valves
Press ENTER to continue
WARNING !
Insufficient vacuum
Press ESC to exit
OIL INJECTION
0
-43-
DD/MM/YY XX:XX PM
ESC
ENTER
DD/MM/YY XX:XX PM
ESC
ENTER
DD/MM/YY XX:XX PM
ESC
DD/MM/YY XX:XX PM
STOP
ml/ 0%